Fruit tree pot automatic drip artifact

Strong pressure compensation, especially suitable for accidented relief, uneven system pressure and long riveting tube. It is resistant to corrosion and ultraviolet rays of agricultural chemicals and fertilizers and has a long service life..

4L pressure compensation emitter 8L pressure compensation emitter 7-hole adjustable emitter 

Pressure compensation range: 0.08-0.4MPa, emitter specification and flow: 4L/h, 8L/h

When the system pressure changes from 0.08 to 0.35Mpa, the flow of the emitter remains unchanged, and the uniformity of irrigation can reach more than 98%.

Features of use:

The installation on the construction site is suitable for any spacing of crops. PE water pipe can be buried below the ground. Small capillaries can be installed at the water inlet or outlet of the emitter, the emitter is led to the ground or the upper part of the crop to prevent sun exposure and prolong the service life of the project.

Suitable occasions: suitable for various terrain and crops, especially in irrigation area with large slope fluctuation; Suitable for the case where the laying length of drip irrigation pipe is large; Suitable for the emitter spacing changes; When the system pressure is unstable.

Applicability:

It can be used for drip irrigation and can adjust the top of the emitter to loosen the cover. According to the water pressure, the water can be sprayed into eight ways, with a wider coverage. It is the first choice for drip irrigation, potted irrigation and small area flower bed. It also applies to the following special cases: